Hallo zusammen,
mal wieder habe ich kleines Thema (wills gerade nicht Problem nennen).
Normalerweise wird über die Fernbedienung bei 1x Unlock drücken die Fahrertür geöffnet und beim 2. mal innerhalb von 5s alle anderen Türen.
Das ging auch bei mir, bis jetzt so.
Jetzt öffnet nur noch die Fahrertür und die anderen bleiben bei nochmaligem drücken zu.
Über die Schalter in den Türen geht alles ganz normal.
Spaßeshalber habe ich mal den Tür-Lock-Modus laut Bedienungsanleitung : "Programmable Automatic Door Locks" neu programmiert und siehe da dann geht erstmal alles wie es soll.
Allerdings ist nach kurzer Zeit wieder der Fehler da. D.h. nur Fahrertür geht per FB auf.
Fällt dazu jemandem was ein? Kanns am BCM liegen?
Nur zur Info :
Programmable Automatic
Door Locks
Your vehicle is equipped with an auto lock/unlock
feature which enables you to program your power
door locks.
Your vehicle left the factory programmed to have all
the doors lock automatically when the shift lever
is moved out of PARK (P). All of the doors will unlock
when the shift lever is moved back into PARK (P).
The following instructions detail how to program your
door locks.
To enter the program mode you need to do the
following:
1. Begin with the ignition in OFF. Then, pull back
on the turn signal/multifunction lever all the way
toward you and hold it while you perform the
next step.
2. Turn your key to RUN and OFF twice. Then, with
the key in OFF, release the turn signal/multifunction
lever. Once you do this, you will hear the lock
switch lock and unlock.
You are now ready to program the automatic door
locks. Select one of the following four programming
options and follow the instructions. You will have thirty
seconds to begin programming. If you exceed the
thirty second limit, the locks will automatically lock and
unlock to indicate that you have left the program
mode. If this occurs, repeat the procedure beginning
with Step 1. You can exit the program mode any time by
turning the ignition to RUN. The locks will automatically
lock and unlock to indicate that you are leaving the
program mode. If the lock/unlock switches are not
pressed while in the programming mode, the auto
lock/unlock setting will not be modified.
The following is a list of the available programming
options:
•
All doors lock/Only the driver’s door unlocks:
Press the lock side of the power lock switch on
the door panel once and then the unlock side once.
•
All doors lock/All doors unlock:
Press the
lock side of the power lock switch on the door
panel once, and then the unlock side twice.
•
All doors lock/None of the doors unlock:
Press
the lock side of the power lock switch on the door
panel once, and then the unlock side three times.
•
No doors lock/None of the doors unlock:
Press
the lock side of the power lock switch on the door
panel twice. This turns off the automatic lock
feature.